Low Voltage ELM327 – firmware version 2.2
This product has been replaced by the v2.3 device
You are advised to use the latest version in your designs, as this device will be discontinued over the next few months.
The following are the unit prices, as you vary the quantity purchased:
All prices are in Canadian dollars. We use the total number purchased (ELM327LP + ELM327LSM + ELM327LSS) for the calculation.
The ELM327L is a low voltage version of our popular ELM327 integrated circuit. It supports all of the features of the ELM327 IC, and only differs physically in how pin 6 is used.
The data sheet discusses the ELM327L in detail, how to use it and how to configure it, as well as providing some background information on the protocols that are supported. There are also schematic diagrams and tips to help you to interface to microprocessors, construct a basic scan tool, and to use the low power mode. Because of the similarity with the ELM327, much of the data sheet has been copied from the ELM327 data sheet.
Throughout the document, the term ‘ELM327’ is often used, but refers to either the ELM327 or the ELM327L. If there is something different between the two, we will be specific as to which it applies to.
- Diagnostic trouble code readers
- Automotive scan tools
- Teaching aids
- Works with a 2.0V to 5.5V supply
- Universal serial (RS232) interface
- Automatically searches for protocols
- Fully configurable with AT commands
- Low power CMOS design
( PDIP or SOIC, top view )
To help us meet demand, Microchip Technology has been programming and labelling some of the ELM327L chips for us. These ICs may look different, but are functionally identical. You may receive ICs that look like those shown above, or as shown below. The differences are only in appearance:
|sku: ELM327LP_V22||sku: ELM327LSM_V22||sku: ELM327LSS_V22|
The following product may also be of interest to you:
And you may find it convenient to order CAN transceivers from us:
The following offer only specific OBD protocols: